![]() But I would suggest going with it instead since it is supposed to be electrically superior and uses less parts so less room for failure I guess. ![]() I've never used this method before so I can't really help as much if you have problems. There has been a new update to the standard wiring you should use for the JTAG wiring on Xenon's which requires just 2x 1n4148 diodes. Refer to the image below to tell what kind of 360 you have. Then you need to Nand dump everything.Toolsġx 25 pin d-sub connector (male or female depending on which kind of cable you have)ġx 25 pin d-sub cable (lpt cable) You can actually skip the cable if you buy a male connector and make your wires long enough to extend from your xbox to the computerģx 330 ohm resistors (only for Xenon motherboards)ġx 1n4148 switching diode (if you have Zephyr, Falcon, Opus or a Jasper get 3x of these) Well actually make sure your kernal on your xbox is. That dosent answer his question he probably knows he can buy one but he wants to make one himself first you need to know how to solder. Insted of doing the jtag yourself, go online and buy a jtaged xbox, it might cost you a llitle bit more, but you will shave a hell of alot of time and effort
0 Comments
Leave a Reply. |